android_kernel_oneplus_msm8998/include/linux/usb/phy.h

362 lines
8.1 KiB
C
Raw Normal View History

/*
* USB PHY defines
*
* These APIs may be used between USB controllers. USB device drivers
* (for either host or peripheral roles) don't use these calls; they
* continue to use just usb_device and usb_gadget.
*/
#ifndef __LINUX_USB_PHY_H
#define __LINUX_USB_PHY_H
#include <linux/notifier.h>
#include <linux/usb.h>
enum usb_phy_interface {
USBPHY_INTERFACE_MODE_UNKNOWN,
USBPHY_INTERFACE_MODE_UTMI,
USBPHY_INTERFACE_MODE_UTMIW,
USBPHY_INTERFACE_MODE_ULPI,
USBPHY_INTERFACE_MODE_SERIAL,
USBPHY_INTERFACE_MODE_HSIC,
};
enum usb_phy_events {
USB_EVENT_NONE, /* no events or cable disconnected */
USB_EVENT_VBUS, /* vbus valid event */
USB_EVENT_ID, /* id was grounded */
USB_EVENT_CHARGER, /* usb dedicated charger */
USB_EVENT_ENUMERATED, /* gadget driver enumerated */
};
/* associate a type with PHY */
enum usb_phy_type {
USB_PHY_TYPE_UNDEFINED,
USB_PHY_TYPE_USB2,
USB_PHY_TYPE_USB3,
};
/* OTG defines lots of enumeration states before device reset */
enum usb_otg_state {
OTG_STATE_UNDEFINED = 0,
/* single-role peripheral, and dual-role default-b */
OTG_STATE_B_IDLE,
OTG_STATE_B_SRP_INIT,
OTG_STATE_B_PERIPHERAL,
usb: phy: Add new OTG state OTG_STATE_B_SUSPENDED This state is used to handle:- - Bus suspend followed by cable disconnect: pm usage count is incremented upon cable connect. Upon bus suspend, suspend interrupt kicks in otg state machine which moves device state to OTG_STATE_B_SUSPENDED from OTG_STATE_B_PERIPHERAL and decrements pm usage count. Upon cable unplug additional decrement of pm usage count is prevented. This state also takes care the handling of cable unplug followed by bus suspend interrupt. - Host initiated resume after bus suspend: Being in OTG_STATE_B_SUSPENDED after bus suspend, upon host initiated resume, wakeup interrupt kicks in otg state machine which moves device to OTG_STATE_B_PERIPHERAL state by incrementing pm usage count. - PC reboot with cable plugged in: After PC shutdown device goes to OTG_STATE_B_SUSPENDED state. After PC start power event irq thread kicks in otg state machine to move device to OTG_STATE_B_PERIPHERAL state and increments pm usage count. - Composition switch after bus suspend: dwc3_gadget_pullup() kicks in otg state machine to move device state from OTG_STATE_B_SUSPENDED to OTG_STATE_B_PERIPHERAL and increments pm usage count to prevent runtime suspend during device enumeration. Also, remove pm_runtime_set_active() which sets the PM runtime stauts as active to avoid pm_runtime_get_sync() failures which explicitly checks for runtime pm status. For example, if status is active, pm_runtime_get_sync() will just increments the counter without actually resuming the device. Change-Id: Id33b81911ef3894a00802b3e553840b9447f6269 Signed-off-by: Hemant Kumar <hemantk@codeaurora.org> [jackp@codeaurora.org: cherry-pick only phy.h and common.c] Signed-off-by: Jack Pham <jackp@codeaurora.org>
2015-04-07 14:42:39 -07:00
OTG_STATE_B_SUSPEND,
/* extra dual-role default-b states */
OTG_STATE_B_WAIT_ACON,
OTG_STATE_B_HOST,
/* dual-role default-a */
OTG_STATE_A_IDLE,
OTG_STATE_A_WAIT_VRISE,
OTG_STATE_A_WAIT_BCON,
OTG_STATE_A_HOST,
OTG_STATE_A_SUSPEND,
OTG_STATE_A_PERIPHERAL,
OTG_STATE_A_WAIT_VFALL,
OTG_STATE_A_VBUS_ERR,
};
struct usb_phy;
struct usb_otg;
/* for phys connected thru an ULPI interface, the user must
* provide access ops
*/
struct usb_phy_io_ops {
int (*read)(struct usb_phy *x, u32 reg);
int (*write)(struct usb_phy *x, u32 val, u32 reg);
};
struct usb_phy {
struct device *dev;
const char *label;
unsigned int flags;
enum usb_phy_type type;
enum usb_phy_events last_event;
struct usb_otg *otg;
struct device *io_dev;
struct usb_phy_io_ops *io_ops;
void __iomem *io_priv;
/* for notification of usb_phy_events */
struct atomic_notifier_head notifier;
/* to pass extra port status to the root hub */
u16 port_status;
u16 port_change;
/* to support controllers that have multiple phys */
struct list_head head;
/* initialize/shutdown the phy */
int (*init)(struct usb_phy *x);
void (*shutdown)(struct usb_phy *x);
/* enable/disable VBUS */
int (*set_vbus)(struct usb_phy *x, int on);
/* effective for B devices, ignored for A-peripheral */
int (*set_power)(struct usb_phy *x,
unsigned mA);
/* Set phy into suspend mode */
int (*set_suspend)(struct usb_phy *x,
int suspend);
/*
* Set wakeup enable for PHY, in that case, the PHY can be
* woken up from suspend status due to external events,
* like vbus change, dp/dm change and id.
*/
int (*set_wakeup)(struct usb_phy *x, bool enabled);
/* notify phy connect status change */
int (*notify_connect)(struct usb_phy *x,
enum usb_device_speed speed);
int (*notify_disconnect)(struct usb_phy *x,
enum usb_device_speed speed);
/* reset the PHY clocks */
int (*reset)(struct usb_phy *x);
/* update DP/DM state */
int (*change_dpdm)(struct usb_phy *x, int dpdm);
};
/**
* struct usb_phy_bind - represent the binding for the phy
* @dev_name: the device name of the device that will bind to the phy
* @phy_dev_name: the device name of the phy
* @index: used if a single controller uses multiple phys
* @phy: reference to the phy
* @list: to maintain a linked list of the binding information
*/
struct usb_phy_bind {
const char *dev_name;
const char *phy_dev_name;
u8 index;
struct usb_phy *phy;
struct list_head list;
};
/* for board-specific init logic */
extern int usb_add_phy(struct usb_phy *, enum usb_phy_type type);
extern int usb_add_phy_dev(struct usb_phy *);
extern void usb_remove_phy(struct usb_phy *);
/* helpers for direct access thru low-level io interface */
static inline int usb_phy_io_read(struct usb_phy *x, u32 reg)
{
if (x && x->io_ops && x->io_ops->read)
return x->io_ops->read(x, reg);
return -EINVAL;
}
static inline int usb_phy_io_write(struct usb_phy *x, u32 val, u32 reg)
{
if (x && x->io_ops && x->io_ops->write)
return x->io_ops->write(x, val, reg);
return -EINVAL;
}
static inline int
usb_phy_init(struct usb_phy *x)
{
if (x && x->init)
return x->init(x);
return 0;
}
static inline void
usb_phy_shutdown(struct usb_phy *x)
{
if (x && x->shutdown)
x->shutdown(x);
}
static inline int
usb_phy_vbus_on(struct usb_phy *x)
{
if (!x || !x->set_vbus)
return 0;
return x->set_vbus(x, true);
}
static inline int
usb_phy_vbus_off(struct usb_phy *x)
{
if (!x || !x->set_vbus)
return 0;
return x->set_vbus(x, false);
}
static inline int
usb_phy_reset(struct usb_phy *x)
{
if (x && x->reset)
return x->reset(x);
return 0;
}
/* for usb host and peripheral controller drivers */
#if IS_ENABLED(CONFIG_USB_PHY)
extern struct usb_phy *usb_get_phy(enum usb_phy_type type);
extern struct usb_phy *devm_usb_get_phy(struct device *dev,
enum usb_phy_type type);
extern struct usb_phy *usb_get_phy_dev(struct device *dev, u8 index);
extern struct usb_phy *devm_usb_get_phy_dev(struct device *dev, u8 index);
extern struct usb_phy *devm_usb_get_phy_by_phandle(struct device *dev,
const char *phandle, u8 index);
extern struct usb_phy *devm_usb_get_phy_by_node(struct device *dev,
struct device_node *node, struct notifier_block *nb);
extern void usb_put_phy(struct usb_phy *);
extern void devm_usb_put_phy(struct device *dev, struct usb_phy *x);
extern int usb_bind_phy(const char *dev_name, u8 index,
const char *phy_dev_name);
extern void usb_phy_set_event(struct usb_phy *x, unsigned long event);
#else
static inline struct usb_phy *usb_get_phy(enum usb_phy_type type)
{
return ERR_PTR(-ENXIO);
}
static inline struct usb_phy *devm_usb_get_phy(struct device *dev,
enum usb_phy_type type)
{
return ERR_PTR(-ENXIO);
}
static inline struct usb_phy *usb_get_phy_dev(struct device *dev, u8 index)
{
return ERR_PTR(-ENXIO);
}
static inline struct usb_phy *devm_usb_get_phy_dev(struct device *dev, u8 index)
{
return ERR_PTR(-ENXIO);
}
static inline struct usb_phy *devm_usb_get_phy_by_phandle(struct device *dev,
const char *phandle, u8 index)
{
return ERR_PTR(-ENXIO);
}
static inline struct usb_phy *devm_usb_get_phy_by_node(struct device *dev,
struct device_node *node, struct notifier_block *nb)
{
return ERR_PTR(-ENXIO);
}
static inline void usb_put_phy(struct usb_phy *x)
{
}
static inline void devm_usb_put_phy(struct device *dev, struct usb_phy *x)
{
}
static inline int usb_bind_phy(const char *dev_name, u8 index,
const char *phy_dev_name)
{
return -EOPNOTSUPP;
}
static inline void usb_phy_set_event(struct usb_phy *x, unsigned long event)
{
}
#endif
static inline int
usb_phy_set_power(struct usb_phy *x, unsigned mA)
{
if (x && x->set_power)
return x->set_power(x, mA);
return 0;
}
static inline int
usb_phy_change_dpdm(struct usb_phy *x, int dpdm)
{
if (x && x->change_dpdm)
return x->change_dpdm(x, dpdm);
return 0;
}
/* Context: can sleep */
static inline int
usb_phy_set_suspend(struct usb_phy *x, int suspend)
{
if (x && x->set_suspend != NULL)
return x->set_suspend(x, suspend);
else
return 0;
}
static inline int
usb_phy_set_wakeup(struct usb_phy *x, bool enabled)
{
if (x && x->set_wakeup)
return x->set_wakeup(x, enabled);
else
return 0;
}
static inline int
usb_phy_notify_connect(struct usb_phy *x, enum usb_device_speed speed)
{
if (x && x->notify_connect)
return x->notify_connect(x, speed);
else
return 0;
}
static inline int
usb_phy_notify_disconnect(struct usb_phy *x, enum usb_device_speed speed)
{
if (x && x->notify_disconnect)
return x->notify_disconnect(x, speed);
else
return 0;
}
/* notifiers */
static inline int
usb_register_notifier(struct usb_phy *x, struct notifier_block *nb)
{
return atomic_notifier_chain_register(&x->notifier, nb);
}
static inline void
usb_unregister_notifier(struct usb_phy *x, struct notifier_block *nb)
{
atomic_notifier_chain_unregister(&x->notifier, nb);
}
static inline const char *usb_phy_type_string(enum usb_phy_type type)
{
switch (type) {
case USB_PHY_TYPE_USB2:
return "USB2 PHY";
case USB_PHY_TYPE_USB3:
return "USB3 PHY";
default:
return "UNKNOWN PHY TYPE";
}
}
#endif /* __LINUX_USB_PHY_H */