Some UFS devices send incorrect LineCfg data as part of power mode change
sequence which may cause host PHY to go into bad state. Currently we
workaround this issue by disabling the device's TX LCC but disabling TX
LCC is much more complicated if both host and device supports UniPro 1.6
specification. To simplify the workaround, this change disables the host
PHY's RX LineCfg to skip processing incorrect LineCfg from device.
Change-Id: I1eac56c11dd001eb0c53ba8e16aa512a656ab9ea
Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org>
[venkatg@codeaurora.org: resolved trivial merge conflicts]
Signed-off-by: Venkat Gopalakrishnan <venkatg@codeaurora.org>
The phy_ops variables are never modified after initialized in these
drivers, so make them const.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Acked-by: Patrice Chotard <patrice.chotard@st.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
This change adds a support for a 20nm qcom-ufs phy that is required in
platforms that use ufs-qcom controller.
Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Reviewed-by: Dov Levenglick <dovl@codeaurora.org>
Signed-off-by: Christoph Hellwig <hch@lst.de>
This change adds a generic and common API support for ufs phy QUALCOMM
Technologies. This support provides common code and also points
to specific phy callbacks to differentiate between different behaviors
of frequent use-cases (like power on, power off, phy calibration etc).
Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Reviewed-by: Dov Levenglick <dovl@codeaurora.org>
Signed-off-by: Christoph Hellwig <hch@lst.de>
