Add logic to support sensor compatibility to fix same
slave address of sensor but different modules on one platform.
Change-Id: I6c6721e8ff890feaf2d618c8170e346367a68c28
Signed-off-by: penliu <pengfeiliu@codeaurora.org>
Signed-off-by: Wei Ding <weiding@codeaurora.org>
A boost current threshold will be referenced in deciding
optimal boost switching frequency for efficiency.
CRs-Fixed: 1095917
Change-Id: I1e738e66cdfb72305dd4256dc0a6e05b03de585e
Signed-off-by: Harry Yang <harryy@codeaurora.org>
Currently, the default boost switching frequency is fixed at 800KHz,
which shows low efficiency in low USB load.
To improve it, only use the default 800KHz when boost current goes
above 100mA; otherwise, switch to 2MHz.
CRs-Fixed: 1095917
Change-Id: Iebb62303febfb78738ada4553fdb9b9eb4810ed5
Signed-off-by: Harry Yang <harryy@codeaurora.org>
This reverts commit 2a8225ef46
("sched/cputime: Fix steal time accounting vs. CPU hotplug").
The commit introduces a bug in scheduler book-keeping whereby if a CPU
is hotplugged out for a small duration of time, subsequent time spent
executing tasks gets mis-attributed to interrupts. This in turn results
in unfair scheduling whereby a task can keep executing for a very long
time without any update to it's vruntime. This revert has no side
effects for msm based systems.
Change-Id: Ibb506824c4223551bceb449594ac99f9dfd8064b
Signed-off-by: Syed Rameez Mustafa <rameezmustafa@codeaurora.org>
Disable the aio interface as we do not use this for performance
benefits.
Change-Id: Ibbe1845c673f3a422b013d17492790c79c78d076
Signed-off-by: Runmin Wang <runminw@codeaurora.org>
The original change to set 200mV boost PFM threshold at request
of a HW workaround is no longer needed, set as default now in
SBL. Remove it.
CRs-Fixed: 1095917
Change-Id: I4e041dafa83d935a5c16c96bea7a3ea488e80d87
Signed-off-by: Harry Yang <harryy@codeaurora.org>
Fix packet handling in case packet received from IPA hardware
is scattered across multiple buffers.
Change-Id: I4935ecb8eaa438d259c1c27a66f62c78f874c9ee
CRs-Fixed: 1097420
Acked-by: Ady Abraham <adya@qti.qualcomm.com>
Signed-off-by: Skylar Chang <chiaweic@codeaurora.org>
Properly initialize variables at the time of declaration.
Change-Id: I6eab6b08cb9ec7bfa6523ab3ed66d086eab89544
Signed-off-by: Rama Krishna Phani A <rphani@codeaurora.org>
Remove the write of acc strap register by default value during Q6 reset
as per Hardware Programming Guide.
Change-Id: Id5b8aaae0783893290e95626b394841a7d3808a3
Signed-off-by: Gaurav Kohli <gkohli@codeaurora.org>
This change adds DPL support using IPA over BAM2BAM.
Initialises two instances of the RmNet Opts structure,
one for RmNet itself and one for DPL. Uses APIs for
QTI and IPA support from RmNet driver.
Change-Id: I76e0c86643331b9623d634bb462faaeb816c0935
Signed-off-by: Ajay Agarwal <ajaya@codeaurora.org>
Add required QMP PHY initialization sequence for msmfalcon for
USB SS mode working.
Change-Id: I14a9f7a1079956efcb3b31ffeca1235a62856bf5
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Update the reset sequence to read each write while enabling QDSP6 memory
bank one at a time. This will make sure whether write is complete or not.
Also add logs during Mss shutdown, It will help to debug Mss restart
and shutdown case.
Change-Id: I9f2cb058a7e59b573fc64662ee7b5bff49b18ea7
Signed-off-by: Gaurav Kohli <gkohli@codeaurora.org>
Calling copy_to_user(to, from, size) with negative value
might cause heap overflow since size is unsigned parameter
and negative value is cast to big unsigned value.
CRs-Fixed: 1092683
Change-Id: I9b4a0710aa33942de2976f7ee158a8025dd6a20e
Signed-off-by: Amir Samuelov <amirs@codeaurora.org>
Whenever composition switch happens, android driver stops data transfers &
removes configuation before disabling pullup. Due to this, there is small
window during which pullup is active and device ends up sending device
descriptor with zero confiurations in certain scenarios of Host PC reboot.
Hence fix the issue by stalling control endpoint in this scenario.
Change-Id: I3d3c0321d9311617c6ee492c55809f36de6ae412
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Signed-off-by: Chandana Kishori Chiluveru <cchiluve@codeaurora.org>
During composition switch, android driver stops data transfers first and
removes configuration before disabling pullup for USB3 controller. With
this sequence there is a possibility for a race where usb_remove_config is
in progress during which pullup is active and sending the setup request for
configuration descriptor with zero configuration value. Hence fix the issue
by adding spinlock protection for get_config descriptor.
CRs-Fixed: 1052608
Change-Id: I65d38387f77addc9a8894a74f427d97313f90a9e
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Signed-off-by: Chandana Kishori Chiluveru <cchiluve@codeaurora.org>
Commit 3dd2172dfecc ("USB: dwc3-msm: Enable power event irq in case of
host bus suspend") is added to enable power_event_irq during host bus
suspend. This is to map MPM pin for DM to power_event_irq to wakeup during
system suspend in host mode. Currently MPM driver has support for mapping
multiple MPM pins to single IRQ. Hence it is not required to enable
power_event_irq during host bus suspend.
Change-Id: I5c7d6b4d43baa0b387342a8bd261361a5c07fe23
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
On qdsss channel close, driver is dequeuing endless request without
checking whether qdss is active or not. This might crash if qdss channel
is closed when non QDSS composition is active. Fix the issue by having
proper checks and if qdss is not active, just return without performing
dequeue operation.
Change-Id: I667ea843f77794e9384c22ece218853331751db6
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Signed-off-by: Chandana Kishori Chiluveru <cchiluve@codeaurora.org>
Add spinlock protection in rndis_qc_command_complete() and
rndis_qc_response_complete() to avoid races with disable and
unbind() function calls. Otherwise it results in crash or using
freed memory.
Change-Id: Ida99de70a541ba12a8a8610b1c6fa717e42d865c
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Signed-off-by: Chandana Kishori Chiluveru <cchiluve@codeaurora.org>
Enable required EHSET Test fixture driver to perform the high speed
electrical testing procedure for USB-IF compliance.
Change-Id: I92cd6cac7315905862aff1c3dde1b4d6ee771128
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
This prevents leakage on 1p8 power rail upon boot up when usb cable
is not connected.
Change-Id: Ia19d54df6086cfb0047fcdd8b04e7e0edff91cf7
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Some usb headsets which do not support remote wakeup when suspended
and resumed by host resulting device disconnect. Hence do not suspend
device if it not remote wake up capable.
Change-Id: Ia2462116582b6e22c44cff88df2872e4127e5e29
Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
Add asm loopback FE DAI to support the audio asm loopback
use case for msm8998 platform.
CRs-Fixed: 1099656
Change-Id: Ia1c6d8dfd75eb21cde8de7b9bfcab4e4277e339f
Signed-off-by: Kuirong Wang <kuirongw@codeaurora.org>
Update speaker left and right GPIOs for APQ8998 platform since it
uses different GPIOs from MSM8998 platform.
CRs-Fixed: 1099656
Change-Id: Idecd865b7a11e4cd30737f5d800673c87807592c
Signed-off-by: Kuirong Wang <kuirongw@codeaurora.org>
Add IPA stats support on AP+STA mode when
CNE queries. Also add metering funtionality
on WIFI interface to stop the data transfer
when quota reached on WIFI-case.
Change-Id: I85da89f681170acf21674a8f1a34778014c92892
Signed-off-by: Skylar Chang <chiaweic@codeaurora.org>
This will fix the race between jpeg dma ISR and userspace call.
Without this fix jpeg dma may randomly crash due to invalid pointer
access.
Change-Id: I559ae08b9a46d5d3c35f8be509976a25faa967f9
CRs-Fixed: 1083323
Signed-off-by: Krishnankutty Kolathappilly <kkolatha@codeaurora.org>
This change enables USBNET driver which allows USB ethernet class
driver to register USB ethernet device as network device with Linux
Network Stack and allows USB IOs with USB Host Controller driver.
Change-Id: Iba036ce43656979df0b9ea228b57bc980c4c53bc
Signed-off-by: Mayank Rana <mrana@codeaurora.org>
