373b13c83b
* origin/tmp-285c137: Linux 4.4.68 block: get rid of blk_integrity_revalidate() drm/ttm: fix use-after-free races in vm fault handling f2fs: sanity check segment count bnxt_en: allocate enough space for ->ntp_fltr_bmap ipv6: reorder ip6_route_dev_notifier after ipv6_dev_notf ipv6: initialize route null entry in addrconf_init() rtnetlink: NUL-terminate IFLA_PHYS_PORT_NAME string ipv4, ipv6: ensure raw socket message is big enough to hold an IP header tcp: do not inherit fastopen_req from parent tcp: fix wraparound issue in tcp_lp bpf, arm64: fix jit branch offset related to ldimm64 tcp: do not underestimate skb->truesize in tcp_trim_head() ALSA: hda - Fix deadlock of controller device lock at unbinding staging: emxx_udc: remove incorrect __init annotations staging: wlan-ng: add missing byte order conversion brcmfmac: Make skb header writable before use brcmfmac: Ensure pointer correctly set if skb data location changes MIPS: R2-on-R6 MULTU/MADDU/MSUBU emulation bugfix scsi: mac_scsi: Fix MAC_SCSI=m option when SCSI=m serial: 8250_omap: Fix probe and remove for PM runtime phy: qcom-usb-hs: Add depends on EXTCON USB: serial: io_edgeport: fix descriptor error handling USB: serial: mct_u232: fix modem-status error handling USB: serial: quatech2: fix control-message error handling USB: serial: ftdi_sio: fix latency-timer error handling USB: serial: ark3116: fix open error handling USB: serial: ti_usb_3410_5052: fix control-message error handling USB: serial: io_edgeport: fix epic-descriptor handling USB: serial: ssu100: fix control-message error handling USB: serial: digi_acceleport: fix incomplete rx sanity check USB: serial: keyspan_pda: fix receive sanity checks usb: chipidea: Handle extcon events properly usb: chipidea: Only read/write OTGSC from one place usb: host: ohci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths usb: host: ehci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths KVM: nVMX: do not leak PML full vmexit to L1 KVM: nVMX: initialize PML fields in vmcs02 Revert "KVM: nested VMX: disable perf cpuid reporting" x86/platform/intel-mid: Correct MSI IRQ line for watchdog device kprobes/x86: Fix kernel panic when certain exception-handling addresses are probed clk: Make x86/ conditional on CONFIG_COMMON_CLK x86/pci-calgary: Fix iommu_free() comparison of unsigned expression >= 0 x86/ioapic: Restore IO-APIC irq_chip retrigger callback mwifiex: Avoid skipping WEP key deletion for AP mwifiex: remove redundant dma padding in AMSDU mwifiex: debugfs: Fix (sometimes) off-by-1 SSID print ARM: OMAP5 / DRA7: Fix HYP mode boot for thumb2 build leds: ktd2692: avoid harmless maybe-uninitialized warning power: supply: bq24190_charger: Handle fault before status on interrupt power: supply: bq24190_charger: Don't read fault register outside irq_handle_thread() power: supply: bq24190_charger: Call power_supply_changed() for relevant component power: supply: bq24190_charger: Install irq_handler_thread() at end of probe() power: supply: bq24190_charger: Call set_mode_host() on pm_resume() power: supply: bq24190_charger: Fix irq trigger to IRQF_TRIGGER_FALLING powerpc/powernv: Fix opal_exit tracepoint opcode cpupower: Fix turbo frequency reporting for pre-Sandy Bridge cores ARM: 8452/3: PJ4: make coprocessor access sequences buildable in Thumb2 mode 9p: fix a potential acl leak ANDROID: android-base.cfg: remove spurious CONFIG_MODULES line ANDROID: memory_state_time: fix undefined behavior with missing DT properties ANDROID: rfkill: fix unused function warning ANDROID: make PF_KEY SHA256 use RFC-compliant truncation. ANDROID: sdcardfs: fix sdcardfs_destroy_inode for the inode RCU approach ANDROID: android-base.cfg: remove NETFILTER_XT_MATCH_QUOTA2_LOG ANDROID: sdcardfs: Don't iput if we didn't igrab ANDROID: Add untag hacks to inet_release function Change-Id: I6d750f8bb186774ff9630beeb0ed8e680af26231 Signed-off-by: Kyle Yan <kyan@codeaurora.org>
87 lines
3.4 KiB
Makefile
87 lines
3.4 KiB
Makefile
# common clock types
|
|
obj-$(CONFIG_HAVE_CLK) += clk-devres.o
|
|
obj-$(CONFIG_CLKDEV_LOOKUP) += clkdev.o
|
|
obj-$(CONFIG_OF) += clk.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-divider.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-fixed-factor.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-fixed-rate.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-gate.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-multiplier.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-mux.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-composite.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-fractional-divider.o
|
|
obj-$(CONFIG_COMMON_CLK) += clk-gpio.o
|
|
ifeq ($(CONFIG_OF), y)
|
|
obj-$(CONFIG_COMMON_CLK) += clk-conf.o
|
|
endif
|
|
|
|
# hardware specific clock types
|
|
# please keep this section sorted lexicographically by file/directory path name
|
|
obj-$(CONFIG_MACH_ASM9260) += clk-asm9260.o
|
|
obj-$(CONFIG_COMMON_CLK_AXI_CLKGEN) += clk-axi-clkgen.o
|
|
obj-$(CONFIG_ARCH_AXXIA) += clk-axm5516.o
|
|
obj-$(CONFIG_COMMON_CLK_CDCE706) += clk-cdce706.o
|
|
obj-$(CONFIG_ARCH_CLPS711X) += clk-clps711x.o
|
|
obj-$(CONFIG_ARCH_EFM32) += clk-efm32gg.o
|
|
obj-$(CONFIG_ARCH_HIGHBANK) += clk-highbank.o
|
|
obj-$(CONFIG_MACH_LOONGSON32) += clk-ls1x.o
|
|
obj-$(CONFIG_COMMON_CLK_MAX_GEN) += clk-max-gen.o
|
|
obj-$(CONFIG_COMMON_CLK_MAX77686) += clk-max77686.o
|
|
obj-$(CONFIG_COMMON_CLK_MAX77802) += clk-max77802.o
|
|
obj-$(CONFIG_ARCH_MB86S7X) += clk-mb86s7x.o
|
|
obj-$(CONFIG_ARCH_MOXART) += clk-moxart.o
|
|
obj-$(CONFIG_ARCH_NOMADIK) += clk-nomadik.o
|
|
obj-$(CONFIG_ARCH_NSPIRE) += clk-nspire.o
|
|
obj-$(CONFIG_COMMON_CLK_PALMAS) += clk-palmas.o
|
|
obj-$(CONFIG_CLK_QORIQ) += clk-qoriq.o
|
|
obj-$(CONFIG_COMMON_CLK_RK808) += clk-rk808.o
|
|
obj-$(CONFIG_COMMON_CLK_S2MPS11) += clk-s2mps11.o
|
|
obj-$(CONFIG_COMMON_CLK_SCPI) += clk-scpi.o
|
|
obj-$(CONFIG_COMMON_CLK_SI5351) += clk-si5351.o
|
|
obj-$(CONFIG_COMMON_CLK_SI514) += clk-si514.o
|
|
obj-$(CONFIG_COMMON_CLK_SI570) += clk-si570.o
|
|
obj-$(CONFIG_COMMON_CLK_CDCE925) += clk-cdce925.o
|
|
obj-$(CONFIG_ARCH_STM32) += clk-stm32f4.o
|
|
obj-$(CONFIG_CLK_TWL6040) += clk-twl6040.o
|
|
obj-$(CONFIG_ARCH_U300) += clk-u300.o
|
|
obj-$(CONFIG_ARCH_VT8500) += clk-vt8500.o
|
|
obj-$(CONFIG_COMMON_CLK_WM831X) += clk-wm831x.o
|
|
obj-$(CONFIG_COMMON_CLK_XGENE) += clk-xgene.o
|
|
obj-$(CONFIG_COMMON_CLK_PWM) += clk-pwm.o
|
|
obj-$(CONFIG_COMMON_CLK_AT91) += at91/
|
|
obj-y += bcm/
|
|
obj-$(CONFIG_ARCH_BERLIN) += berlin/
|
|
obj-$(CONFIG_ARCH_HISI) += hisilicon/
|
|
obj-$(CONFIG_ARCH_MXC) += imx/
|
|
obj-$(CONFIG_MACH_INGENIC) += ingenic/
|
|
obj-$(CONFIG_COMMON_CLK_KEYSTONE) += keystone/
|
|
obj-$(CONFIG_ARCH_MEDIATEK) += mediatek/
|
|
ifeq ($(CONFIG_COMMON_CLK), y)
|
|
obj-$(CONFIG_ARCH_MMP) += mmp/
|
|
endif
|
|
obj-$(CONFIG_PLAT_ORION) += mvebu/
|
|
obj-$(CONFIG_ARCH_MESON) += meson/
|
|
obj-$(CONFIG_ARCH_MXS) += mxs/
|
|
obj-$(CONFIG_ARCH_LPC18XX) += nxp/
|
|
obj-$(CONFIG_MACH_PISTACHIO) += pistachio/
|
|
obj-$(CONFIG_COMMON_CLK_PXA) += pxa/
|
|
obj-$(CONFIG_COMMON_CLK_QCOM) += qcom/
|
|
obj-$(CONFIG_ARCH_ROCKCHIP) += rockchip/
|
|
obj-$(CONFIG_COMMON_CLK_SAMSUNG) += samsung/
|
|
obj-$(CONFIG_ARCH_SHMOBILE_MULTI) += shmobile/
|
|
obj-$(CONFIG_ARCH_SIRF) += sirf/
|
|
obj-$(CONFIG_ARCH_SOCFPGA) += socfpga/
|
|
obj-$(CONFIG_PLAT_SPEAR) += spear/
|
|
obj-$(CONFIG_ARCH_STI) += st/
|
|
obj-$(CONFIG_ARCH_SUNXI) += sunxi/
|
|
obj-$(CONFIG_ARCH_TEGRA) += tegra/
|
|
obj-$(CONFIG_ARCH_OMAP2PLUS) += ti/
|
|
obj-$(CONFIG_ARCH_U8500) += ux500/
|
|
obj-$(CONFIG_COMMON_CLK_VERSATILE) += versatile/
|
|
ifeq ($(CONFIG_COMMON_CLK), y)
|
|
obj-$(CONFIG_X86) += x86/
|
|
endif
|
|
obj-$(CONFIG_ARCH_ZX) += zte/
|
|
obj-$(CONFIG_ARCH_ZYNQ) += zynq/
|
|
obj-$(CONFIG_H8300) += h8300/
|
|
obj-$(CONFIG_ARCH_QCOM) += msm/
|