Felix Fietkau 00c86590e3 ath9k_hw: clean up and fix initial noise floor calibration ... On AR9003 the initial noise floor calibration is currently triggered at the end of the reset without allowing the hardware to update the baseband settings. This could potentially make scans in noisy environments a bit more unreliable, so use the same calibration sequence that is used on AR9002. Signed-off-by: Felix Fietkau <nbd@openwrt.org> Acked-by: Luis R. Rodriguez <lrodriguez@atheros.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>		2010-08-04 15:27:36 -04:00
..
ahb.c	drivers/net/wireless: Use wiphy_<level>	2010-07-27 15:14:13 -04:00
ani.c
ani.h
ar5008_initvals.h	ath9k_hw: reformat the ar5008, ar9001 and ar9002 initvals to match ar9003	2010-07-02 13:44:34 -04:00
ar5008_phy.c	ath9k_hw: fix invalid extension channel noisefloor readings in HT20	2010-07-26 15:32:42 -04:00
ar9001_initvals.h	ath9k_hw: sync initvals for ar9001 and ar9002 with Atheros	2010-07-02 13:44:35 -04:00
ar9002_calib.c	ath9k_hw: clean up and fix initial noise floor calibration	2010-08-04 15:27:36 -04:00
ar9002_hw.c	ath9k_hw: remove initvals for hardware which was never sold	2010-07-14 13:52:46 -04:00
ar9002_initvals.h	ath9k_hw: remove initvals for hardware which was never sold	2010-07-14 13:52:46 -04:00
ar9002_mac.c	ath9k_hw: report the TID in the tx status on AR5008-AR9002	2010-07-12 16:05:38 -04:00
ar9002_phy.c	ath9k_hw: fix invalid extension channel noisefloor readings in HT20	2010-07-26 15:32:42 -04:00
ar9002_phy.h	ath9k_hw: sanitize noise floor values properly on all chips	2010-07-02 13:44:36 -04:00
ar9003_2p0_initvals.h
ar9003_2p2_initvals.h
ar9003_calib.c	ath9k_hw: clean up and fix initial noise floor calibration	2010-08-04 15:27:36 -04:00
ar9003_eeprom.c	ath9k_hw: fix antenna diversity on AR9285	2010-07-12 16:05:37 -04:00
ar9003_eeprom.h
ar9003_hw.c	ath9k_hw: dynamically choose the SERDES array for low power	2010-06-23 15:14:03 -04:00
ar9003_mac.c	ath9k_hw: Fix AR9003 MPDU delimeter CRC check for middle subframes	2010-07-16 14:03:42 -04:00
ar9003_mac.h	ath9k_hw: report the TID in the tx status on AR5008-AR9002	2010-07-12 16:05:38 -04:00
ar9003_paprd.c
ar9003_phy.c	ath9k_hw: fix invalid extension channel noisefloor readings in HT20	2010-07-26 15:32:42 -04:00
ar9003_phy.h
ath9k.h	ath9k: Fix inconsistency between txq->stopped and the actual queue state	2010-07-26 15:32:41 -04:00
beacon.c
btcoex.c
btcoex.h
calib.c	ath9k_hw: clean up and fix initial noise floor calibration	2010-08-04 15:27:36 -04:00
calib.h	ath9k_hw: clean up and fix initial noise floor calibration	2010-08-04 15:27:36 -04:00
common.c	ath9k: fix crash with WEP in ad-hoc mode	2010-07-02 13:44:38 -04:00
common.h
debug.c
debug.h
eeprom.c
eeprom.h	ath9k_hw: fix antenna diversity on AR9285	2010-07-12 16:05:37 -04:00
eeprom_4k.c	ath9k: remove unneeded calculation of minimal calibration power	2010-07-14 13:52:45 -04:00
eeprom_9287.c	ath9k: remove unneeded calculation of minimal calibration power	2010-07-14 13:52:45 -04:00
eeprom_def.c	ath9k: remove unneeded calculation of minimal calibration power	2010-07-14 13:52:45 -04:00
gpio.c	ath9k: Add a module parameter to disable led blinking.	2010-06-23 15:14:05 -04:00
hif_usb.c	Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-2.6	2010-07-13 15:31:51 -04:00
hif_usb.h
htc.h	ath9k_htc: Add LED support for AR7010	2010-06-30 15:00:53 -04:00
htc_drv_beacon.c
htc_drv_init.c
htc_drv_main.c	ath9k: snprintf() returns largish values	2010-07-26 15:32:41 -04:00
htc_drv_txrx.c
htc_hst.c
htc_hst.h
hw-ops.h	ath9k: merge noisefloor load implementations	2010-07-12 16:05:39 -04:00
hw.c	ath9k_hw: clean up and fix initial noise floor calibration	2010-08-04 15:27:36 -04:00
hw.h	ath9k: merge noisefloor load implementations	2010-07-12 16:05:39 -04:00
init.c	ath9k: fix panic while cleaning up virtaul wifis	2010-07-14 13:52:45 -04:00
Kconfig
mac.c
mac.h	ath9k_hw: report the TID in the tx status on AR5008-AR9002	2010-07-12 16:05:38 -04:00
main.c	ath9k: remove the two wiphys scanning at the same time message	2010-07-28 16:24:01 -04:00
Makefile
pci.c	drivers/net/wireless: Use wiphy_<level>	2010-07-27 15:14:13 -04:00
phy.h
rc.c	ath9k: remove unused base_index from rate table.	2010-07-27 14:59:59 -04:00
rc.h	ath9k: remove unused base_index from rate table.	2010-07-27 14:59:59 -04:00
recv.c
reg.h	ath9k_htc: Add LED support for AR7010	2010-06-30 15:00:53 -04:00
virtual.c	ath9k: Fix inconsistency between txq->stopped and the actual queue state	2010-07-26 15:32:41 -04:00
wmi.c
wmi.h
xmit.c	ath9k: fix yet another buffer leak in the tx aggregation code	2010-07-26 15:32:42 -04:00