Vivek Natarajan 08e75ea84c ath10k: Support different txbf configuration schemes ... qca61x4 uses the vdev param as a sole sufficient configuration for txbf while qca99x0 enables txbf during peer assoc by combining the vdev param value with peer assoc's vht capabilities This patch gets the appropriate txbf configuration scheme before passing the wmi command to enable the same in the firmware. Signed-off-by: Vivek Natarajan <nataraja@qti.qualcomm.com> Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>		2015-08-13 14:21:10 +03:00
..
bmi.c
bmi.h	ath10k: Fix BMI communication timeout for QCA99X0	2015-06-30 15:12:46 +03:00
ce.c	ath10k: Extend CE src desc flags for interrupt indication	2015-06-30 15:12:44 +03:00
ce.h	ath10k: Extend CE src desc flags for interrupt indication	2015-06-30 15:12:44 +03:00
core.c	ath10k: fix memory alloc failure in qca99x0 during wmi svc rdy event	2015-07-30 16:54:28 +03:00
core.h	ath10k: fix memory alloc failure in qca99x0 during wmi svc rdy event	2015-07-30 16:54:28 +03:00
debug.c	ath10k: enable raw encap mode and software crypto engine	2015-07-29 11:28:24 +03:00
debug.h	ath10k: enable pci soc powersaving	2015-05-22 13:39:28 +03:00
debugfs_sta.c
hif.h
htc.c	ath10k: replenish htc tx credits always	2015-04-09 14:58:16 +03:00
htc.h
htt.c	ath10k: enable raw encap mode and software crypto engine	2015-07-29 11:28:24 +03:00
htt.h	ath10k: enable raw encap mode and software crypto engine	2015-07-29 11:28:24 +03:00
htt_rx.c	ath10k: enable raw encap mode and software crypto engine	2015-07-29 11:28:24 +03:00
htt_tx.c	ath10k: initialize msdu ext. descriptor before use	2015-07-30 17:05:29 +03:00
hw.c	ath10k: fix QCA61X4 boot up	2015-07-11 19:06:15 +03:00
hw.h	ath10k: increase max client to 512 in qca99x0	2015-07-30 16:54:57 +03:00
Kconfig
mac.c	ath10k: Support different txbf configuration schemes	2015-08-13 14:21:10 +03:00
mac.h	ath10k: fix per-vif queue locking	2015-07-11 19:06:26 +03:00
Makefile	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
p2p.c	ath10k: implement handling of p2p noa event	2015-03-07 09:57:42 +02:00
p2p.h	ath10k: implement handling of p2p noa event	2015-03-07 09:57:42 +02:00
pci.c	ath10k: add QCA99X0 to supported device list	2015-07-30 17:04:00 +03:00
pci.h	ath10k: Make target cpu address to CE address conversion chip specific	2015-06-30 15:12:40 +03:00
rx_desc.h	ath10k: add support for qca99x0 Rx descriptors	2015-07-24 10:44:55 +03:00
spectral.c	ath10k: increase relay buffer size of spectral scan	2015-05-11 17:50:42 +03:00
spectral.h
swap.c	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
swap.h	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
targaddrs.h	ath10k: Add hw register/values for QCA99X0 chip	2015-06-30 15:12:37 +03:00
testmode.c
testmode.h
testmode_i.h
thermal.c	ath10k: don't call quiet mode if it's not implemented	2015-04-01 20:21:17 +03:00
thermal.h	ath10k: configure thermal throttle while powering up	2015-03-23 17:16:37 +02:00
trace.c
trace.h	ath10k: add extra check for frame tracing	2015-04-17 09:33:48 +03:00
txrx.c	ath10k: Improve performance by reducing tx_lock contention	2015-07-29 11:27:24 +03:00
txrx.h
wmi-ops.h	ath10k: Support different txbf configuration schemes	2015-08-13 14:21:10 +03:00
wmi-tlv.c	ath10k: Support different txbf configuration schemes	2015-08-13 14:21:10 +03:00
wmi-tlv.h	ath10k: implement tx pause wmi event	2015-04-01 20:31:08 +03:00
wmi.c	ath10k: Support different txbf configuration schemes	2015-08-13 14:21:10 +03:00
wmi.h	ath10k: Support different txbf configuration schemes	2015-08-13 14:21:10 +03:00
wow.c	ath10k: add WOW patterns support	2015-03-30 09:10:24 +03:00
wow.h	ath10k: add WOW patterns support	2015-03-30 09:10:24 +03:00