Raja Mani 721ad3ca79 ath10k: add 10.4 fw specific htt msg definitions ... New htt event table is added for 10.4 firmware. Following new htt events are available only 10.4. adding this to generic htt event table, HTT_T2H_MSG_TYPE_EN_STATS, HTT_T2H_MSG_TYPE_TX_FETCH_IND, HTT_T2H_MSG_TYPE_TX_FETCH_CONF, HTT_T2H_MSG_TYPE_TX_LOW_LATENCY_IND Signed-off-by: Raja Mani <rmani@qti.qualcomm.com> Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>		2015-07-02 08:47:18 +03:00
..
bmi.c
bmi.h	ath10k: Fix BMI communication timeout for QCA99X0	2015-06-30 15:12:46 +03:00
ce.c	ath10k: Extend CE src desc flags for interrupt indication	2015-06-30 15:12:44 +03:00
ce.h	ath10k: Extend CE src desc flags for interrupt indication	2015-06-30 15:12:44 +03:00
core.c	ath10k: add 10.4 fw specific htt msg definitions	2015-07-02 08:47:18 +03:00
core.h	ath10k: handle 10.4 firmware wmi swba event	2015-07-02 08:47:12 +03:00
debug.c	ath10k: print htt op_version upon driver boot	2015-06-16 13:06:47 +03:00
debug.h	ath10k: enable pci soc powersaving	2015-05-22 13:39:28 +03:00
debugfs_sta.c
hif.h
htc.c	ath10k: replenish htc tx credits always	2015-04-09 14:58:16 +03:00
htc.h
htt.c	ath10k: add 10.4 fw specific htt msg definitions	2015-07-02 08:47:18 +03:00
htt.h	ath10k: add 10.4 fw specific htt msg definitions	2015-07-02 08:47:18 +03:00
htt_rx.c	ath10k: add 10.4 fw specific htt msg definitions	2015-07-02 08:47:18 +03:00
htt_tx.c	ath10k: rework tx queue locking	2015-04-01 20:31:00 +03:00
hw.c	ath10k: Extend CE src desc flags for interrupt indication	2015-06-30 15:12:44 +03:00
hw.h	ath10k: add 10.4 fw specific htt msg definitions	2015-07-02 08:47:18 +03:00
Kconfig
mac.c	ath10k: include new wmi op version for 10.4 fw	2015-06-30 15:31:01 +03:00
mac.h	ath10k: implement tx pause wmi event	2015-04-01 20:31:08 +03:00
Makefile	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
p2p.c	ath10k: implement handling of p2p noa event	2015-03-07 09:57:42 +02:00
p2p.h	ath10k: implement handling of p2p noa event	2015-03-07 09:57:42 +02:00
pci.c	ath10k: Add chip reset sequence for QCA99X0	2015-06-30 15:12:42 +03:00
pci.h	ath10k: Make target cpu address to CE address conversion chip specific	2015-06-30 15:12:40 +03:00
rx_desc.h	ath10k: add hw rate definitions	2015-03-30 15:09:15 +03:00
spectral.c	ath10k: increase relay buffer size of spectral scan	2015-05-11 17:50:42 +03:00
spectral.h
swap.c	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
swap.h	ath10k: Add support for code swap	2015-06-30 15:12:47 +03:00
targaddrs.h	ath10k: Add hw register/values for QCA99X0 chip	2015-06-30 15:12:37 +03:00
testmode.c
testmode.h
testmode_i.h
thermal.c	ath10k: don't call quiet mode if it's not implemented	2015-04-01 20:21:17 +03:00
thermal.h	ath10k: configure thermal throttle while powering up	2015-03-23 17:16:37 +02:00
trace.c
trace.h	ath10k: add extra check for frame tracing	2015-04-17 09:33:48 +03:00
txrx.c	ath10k: txrx: remove unreachable negative return check and fixup type	2015-06-16 13:14:54 +03:00
txrx.h
wmi-ops.h	ath10k: implement adaptive qcs command	2015-04-01 20:30:52 +03:00
wmi-tlv.c	ath10k: enhance swba event handler to adapt different size tim bitmap	2015-07-02 08:47:11 +03:00
wmi-tlv.h	ath10k: implement tx pause wmi event	2015-04-01 20:31:08 +03:00
wmi.c	ath10k: add scan support for 10.4 fw	2015-07-02 08:47:16 +03:00
wmi.h	ath10k: add scan support for 10.4 fw	2015-07-02 08:47:16 +03:00
wow.c	ath10k: add WOW patterns support	2015-03-30 09:10:24 +03:00
wow.h	ath10k: add WOW patterns support	2015-03-30 09:10:24 +03:00