* origin/tmp-285c137: Linux 4.4.68 block: get rid of blk_integrity_revalidate() drm/ttm: fix use-after-free races in vm fault handling f2fs: sanity check segment count bnxt_en: allocate enough space for ->ntp_fltr_bmap ipv6: reorder ip6_route_dev_notifier after ipv6_dev_notf ipv6: initialize route null entry in addrconf_init() rtnetlink: NUL-terminate IFLA_PHYS_PORT_NAME string ipv4, ipv6: ensure raw socket message is big enough to hold an IP header tcp: do not inherit fastopen_req from parent tcp: fix wraparound issue in tcp_lp bpf, arm64: fix jit branch offset related to ldimm64 tcp: do not underestimate skb->truesize in tcp_trim_head() ALSA: hda - Fix deadlock of controller device lock at unbinding staging: emxx_udc: remove incorrect __init annotations staging: wlan-ng: add missing byte order conversion brcmfmac: Make skb header writable before use brcmfmac: Ensure pointer correctly set if skb data location changes MIPS: R2-on-R6 MULTU/MADDU/MSUBU emulation bugfix scsi: mac_scsi: Fix MAC_SCSI=m option when SCSI=m serial: 8250_omap: Fix probe and remove for PM runtime phy: qcom-usb-hs: Add depends on EXTCON USB: serial: io_edgeport: fix descriptor error handling USB: serial: mct_u232: fix modem-status error handling USB: serial: quatech2: fix control-message error handling USB: serial: ftdi_sio: fix latency-timer error handling USB: serial: ark3116: fix open error handling USB: serial: ti_usb_3410_5052: fix control-message error handling USB: serial: io_edgeport: fix epic-descriptor handling USB: serial: ssu100: fix control-message error handling USB: serial: digi_acceleport: fix incomplete rx sanity check USB: serial: keyspan_pda: fix receive sanity checks usb: chipidea: Handle extcon events properly usb: chipidea: Only read/write OTGSC from one place usb: host: ohci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths usb: host: ehci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths KVM: nVMX: do not leak PML full vmexit to L1 KVM: nVMX: initialize PML fields in vmcs02 Revert "KVM: nested VMX: disable perf cpuid reporting" x86/platform/intel-mid: Correct MSI IRQ line for watchdog device kprobes/x86: Fix kernel panic when certain exception-handling addresses are probed clk: Make x86/ conditional on CONFIG_COMMON_CLK x86/pci-calgary: Fix iommu_free() comparison of unsigned expression >= 0 x86/ioapic: Restore IO-APIC irq_chip retrigger callback mwifiex: Avoid skipping WEP key deletion for AP mwifiex: remove redundant dma padding in AMSDU mwifiex: debugfs: Fix (sometimes) off-by-1 SSID print ARM: OMAP5 / DRA7: Fix HYP mode boot for thumb2 build leds: ktd2692: avoid harmless maybe-uninitialized warning power: supply: bq24190_charger: Handle fault before status on interrupt power: supply: bq24190_charger: Don't read fault register outside irq_handle_thread() power: supply: bq24190_charger: Call power_supply_changed() for relevant component power: supply: bq24190_charger: Install irq_handler_thread() at end of probe() power: supply: bq24190_charger: Call set_mode_host() on pm_resume() power: supply: bq24190_charger: Fix irq trigger to IRQF_TRIGGER_FALLING powerpc/powernv: Fix opal_exit tracepoint opcode cpupower: Fix turbo frequency reporting for pre-Sandy Bridge cores ARM: 8452/3: PJ4: make coprocessor access sequences buildable in Thumb2 mode 9p: fix a potential acl leak ANDROID: android-base.cfg: remove spurious CONFIG_MODULES line ANDROID: memory_state_time: fix undefined behavior with missing DT properties ANDROID: rfkill: fix unused function warning ANDROID: make PF_KEY SHA256 use RFC-compliant truncation. ANDROID: sdcardfs: fix sdcardfs_destroy_inode for the inode RCU approach ANDROID: android-base.cfg: remove NETFILTER_XT_MATCH_QUOTA2_LOG ANDROID: sdcardfs: Don't iput if we didn't igrab ANDROID: Add untag hacks to inet_release function Change-Id: I6d750f8bb186774ff9630beeb0ed8e680af26231 Signed-off-by: Kyle Yan <kyan@codeaurora.org> |
||
---|---|---|
.. | ||
android-base.cfg | ||
android-recommended.cfg | ||
README |
The files in this directory are meant to be used as a base for an Android kernel config. All devices should have the options in android-base.cfg enabled. While not mandatory, the options in android-recommended.cfg enable advanced Android features. Assuming you already have a minimalist defconfig for your device, a possible way to enable these options would be: ARCH=<arch> scripts/kconfig/merge_config.sh <path_to>/<device>_defconfig android/configs/android-base.cfg android/configs/android-recommended.cfg This will generate a .config that can then be used to save a new defconfig or compile a new kernel with Android features enabled. Because there is no tool to consistently generate these config fragments, lets keep them alphabetically sorted instead of random.