The msm_camera_tz_set_mode is called for TA notification
and if the notification fails the flow should still proceed
without return.
This change prevents a fault caused by vfe remaining in
secure mode as the detach was not called in case of
notification failure.
CRs-Fixed: 2011627
Change-Id: Iefcfd72c8e2d96aba2daf2bed8d271edee0cc8c1
Signed-off-by: Dany Rybnikov <danyr@codeaurora.org>
Add efuse register to be read for VFE dual camera limitation.
Change-Id: I1562b4555aadd0fde8f644cc3aa61e9d45f98ef0
Signed-off-by: Venu Yeshala <vyeshala@codeaurora.org>
Remove gt9xx goodix touch driver from the kernel code
as it has never been used in any of the recent platforms.
Change-Id: If9ebe97dee81d7a95a64c560b605c2e1d02b837c
Signed-off-by: Shantanu Jain <shjain@codeaurora.org>
The charger therm on RRADC only reads valid values if a charger is
present. Add a check accordingly.
Change-Id: I74c6c15e1e72d4d2ef3ffd698f130b7d0fce6df4
Signed-off-by: Ashay Jaiswal <ashayj@codeaurora.org>
Add the proper clock handle to USB dt node for noc_aggr_clk for
SDM660.
Change-Id: Id9ec52123ce2e45b466cc6cd74696f52154efdae
Signed-off-by: Vijayavardhan Vennapusa <vvreddy@codeaurora.org>
Increase the size of host to target CE4 ring
in order to hold more data packets in the ring and
avoid the unnecessary drops at hif layer.
CRs-Fixed: 2017758
Change-Id: Ib344c7035a79b0730a8b39d2441857b363e18efd
Signed-off-by: Govind Singh <govinds@codeaurora.org>
TCP TX throttling logic is changed a little after
3.19-rc1 kernel, the TCP sending limit will be smaller,
which will throttle the TCP packets to the host driver.
The TCP UP LINK throughput will drop heavily. In order to
fix this issue, need to orphan the socket buffer asap, which
will call skb's destructor to notify the TCP stack that the
SKB buffer is unowned. And then the TCP stack will pump more
packets to host driver.
The TX packets might be dropped for UDP case in the iperf
testing. So need to be protected by follow control
Change-Id: I1c77313fbdb579e708d4a5a6bcd063c7c34a6d39
Signed-off-by: Govind Singh <govinds@codeaurora.org>
On certain PMICs, PMIC peripheral drivers like haptics need to
read MISC peripheral register. Add support for clients to read
it by using qpnp_misc_read_reg().
Change-Id: Id5dfd9e440a8861b56572dab50839d1583535882
Signed-off-by: Subbaraman Narayanamurthy <subbaram@codeaurora.org>
