Currently, there is a possibility that read buffers are
not initialized but diag ends up marking buffers busy and
stops reading from peripheral, which leads to port loss.
Also reset the in_busy variable for the buffer that reads
the data from smd channel when diag smd state is closed.
CRs-Fixed: 1093989
Change-Id: I1990d0ded5a212c9185c149ac297a3630d64bc59
Signed-off-by: Mohit Aggarwal <maggarwa@codeaurora.org>
Remove msm_bus bandwidth vote from DT for msm8998
as WLAN FW will take care of it.
CRs-Fixed: 1094917
Change-Id: Ied5dcb9e3283dc2ec7f5fd6f03465b070f989d8b
Signed-off-by: Yuanyuan Liu <yuanliu@codeaurora.org>
Modify ACD_EXTINT_CFG so that ACD calibrates every time OSM toggles
full freq signal. This is recommended by hardware guidelines to
prevent ACD from mitigating when CPU clock frequency is boosted.
CRs-Fixed: 1088429
Change-Id: I07856ea8b332dbf12654fdd0b5d5518355f1c350
Signed-off-by: Osvaldo Banuelos <osvaldob@codeaurora.org>
Add mem-acc threshold and crossover voltage properties to the
VDD_APC0/1 CPR devices and a matching mem-acc crossover voltage
to the OSM device. Update the APM threshold voltage
to 800 mV for both clusters.
CRs-Fixed: 1088429
Change-Id: I747fd7665401803998b2824ace6dedbc5797b17f
Signed-off-by: Osvaldo Banuelos <osvaldob@codeaurora.org>
Add support for configuring the highest memory accelerator
(MEM ACC) threshold voltage. This threshold voltage is used at
runtime to determine which CPRh virtual corner to program into
the OSM sequencer registers in place of the fixed MEM ACC
configuration specified in the OSM LUT.
CRs-Fixed: 1088429
Change-Id: Ida29eaca139c1ddd6439d11a8bd51526366f2a34
Signed-off-by: David Collins <collinsd@codeaurora.org>
Add support for configuring the memory accelerator (MEM ACC)
threshold voltage and the MEM ACC crossover voltage.
The threshold voltage is used to restrict the floor to ceiling
voltage range of all corners so that they cannot cross the
the MEM ACC threshold voltage due to CPR operation. The
crossover voltage is set when switching the MEM ACC
configuration.
If specified, the APM and MEM ACC crossover voltages are added
to the array of corners after all true corners. If both are
specified, then the APM crossover corner is added before the MEM
ACC crossover corner (i.e. last corner = MEM ACC crossover and
second to last corner = APM crossover).
CRs-Fixed: 1088429
Change-Id: I2b9b746071579ba9d4bcdcfb6cb755ca08a73182
Signed-off-by: David Collins <collinsd@codeaurora.org>
