Tavil is sourced from lnbbclk2 and hence enable
this clock for tavil codec.
CRs-Fixed: 1041199
Change-Id: I5409b0f4ed58fefdd25abbe79f144de7e693c1a1
Signed-off-by: Yeleswarapu Nagaradhesh <nagaradh@codeaurora.org>
Add wcd934x as a mfd child and configure regmap.
Configure MCLK as per the HW sequence.
CRs-Fixed: 1041199
Change-Id: I9e2dbb0f0acaa1442c1624556bc52abf98158c92
Signed-off-by: Yeleswarapu Nagaradhesh <nagaradh@codeaurora.org>
Vote on the active-only CX voltage rail resource on behalf of
the hmss_ahb_clk. This way, when APPS attempts to go to sleep
and the clock is disabled, the corresponding voltage vote is
removed as well.
CRs-Fixed: 1042533
Change-Id: I6e20f4c00ec4555ecbae2adbb33287aed268639e
Signed-off-by: Deepak Katragadda <dkatraga@codeaurora.org>
SMD clients for DSPS have migrated to G-Link.
Remove SMD device for DSPS edge.
CRs-Fixed: 1041462
Change-Id: I9f62cc0e8229b86500fa72908be5c503847aed8f
Signed-off-by: Chris Lew <clew@codeaurora.org>
SMD clients for ADSP have migrated to G-Link.
Remove SMD device for ADSP edge.
CRs-Fixed: 1041461
Change-Id: I299d31569291e90431802059f727a57ea0f76200
Signed-off-by: Chris Lew <clew@codeaurora.org>
SMD clients for Modem have migrated to G-Link.
Remove SMD device for Modem edge.
CRs-Fixed: 1041459
Change-Id: I6122ceb014f70b8e0ac005bc3789fbd13a3e867a
Signed-off-by: Chris Lew <clew@codeaurora.org>
Add isp version for cobalt. The version is used by the driver
to differentiate in the code paths based on the isp type.
CRs-Fixed: 1038370
Change-Id: I81055befae23b95bd7ba7dbe32c13be642bee66d
Signed-off-by: Shubhraprakash Das <sadas@codeaurora.org>
It has been observed that default values for some of key tcp/ip
parameters are affecting the tput/performance of the system. Hence
extending configuration capabilities to TCP/Ip stack through
sysctl interface
Change-Id: I4287e9103769535f43e0934bac08435a524ee6a4
CRs-Fixed: 507581
Signed-off-by: Ravi Joshi <ravij@codeaurora.org>
Signed-off-by: Ganesh Babu Kumaravel <kganesh@codeaurora.org>
Signed-off-by: Mohit Khanna <mkhannaqca@codeaurora.org>
The gcc_bimc_hmss_axi_clk will be configured outside of HLOS.
The linux clock driver does not need to manually enable it.
CRs-Fixed: 1012646
Change-Id: Ib0b848fb410f4bf266b09cefed0e8bce7292d2ec
Signed-off-by: Deepak Katragadda <dkatraga@codeaurora.org>
Update decimator high pass filter cutoff frequency if the
TX is path closed within 300ms after opening the session.
This will restore the cutoff frequency to the default
correct value.
CRs-fixed: 988075
Change-Id: Iece28fe2551a74ec7b1b8b4b5cac02537e3d28d8
Signed-off-by: Phani Kumar Uppalapati <phaniu@codeaurora.org>
If a USB charger is already attached before the master charger
probes, the master will miss updating parallel charging states.
ICL and charge state change interrupts get triggered before
their handlers are registered. Hence these interrupts will not
be handled. Obtain the state of missing interrupts by polling
status registers.
If parallel charging is ready on master side before the parallel
charger probes, then parallel charging will not be enabled.
Check if parallel charging is ready once the parallel charger
probes so parallel charging can be enabled immediately.
CRs-Fixed: 1033688
Change-Id: Ic91baeaeb7410b6f265b8bfa8e31e2bcff8dfce2
Signed-off-by: Harry Yang <harryy@codeaurora.org>
This change adds debug event to capture pull up operation request.
It also captures if software fails to perfrom pull-up operation
here.
CRs-Fixed: 1036037
Change-Id: I77ecff3a2ac395ff3799c1b0618fbc7f5eeb03da
Signed-off-by: Mayank Rana <mrana@codeaurora.org>
When clients dumps PCIe PARF registers, it should not flood
dmesg. Change the logging type for dumping PCIe PARF register
to a lower priority one. The dump will only show up in PCIe
specific logs and not dmesg.
Change-Id: Ide04b0d2017ce3c1a99edd2b38ef5b06178a1f41
Signed-off-by: Tony Truong <truong@codeaurora.org>
The peripheral_mem carveout currently contains three separate images.
If these images are dynamically unloaded and reloaded in the wrong
order they could fragment the memory such that not all images would
fit.
Break apart the peripheral_mem into separate carveouts for each PIL
image to avoid the possibility of fragmentation.
CRs-Fixed: 1024397
Change-Id: Id9607b7e4a5e0cdcbf4c36ffad32536dd0669005
Signed-off-by: Liam Mark <lmark@codeaurora.org>
