ADV7481 driver is board-specific, and thus should be compiled
as a module. This is part of the kernel modularization requirement.
Change-Id: I38ab9efca34ac9f898c2b76843563d8f74c29320
Suggested-by: Resmi Rajendran <resmir@qti.qualcomm.com>
Signed-off-by: Rahul Sharma <sharah@codeaurora.org>
Reset ASRC after audio playback is completed to clear
the FIFO and avoid any noise being generated.
CRs-Fixed: 2129994
Change-Id: Ie45796e1bd68d5a8bd790490a65520358f26b811
Signed-off-by: Walter Yang <yandongy@codeaurora.org>
Add kernel pointer restriction while printing the global
page table entries through the debugfs.
Change-Id: Ia2ef4243248ece477e3f679c0027379686670928
Signed-off-by: Hareesh Gundu <hareeshg@codeaurora.org>
Add SLPI fw name property to support dynamic loading of SLPI
fw images based on the version info.
Change-Id: I31baf971106a7a076cf83bd72c4509d860b3e7cb
Signed-off-by: Ananda Kishore <kananda@codeaurora.org>
Add support for clients to notify SRM update
to HDCP 1.x driver.
Integrate the SRM validation check in the HDCP 1.x
authentication flow to check HDCP 1.x receiver/repeater
KSV against the SRM revoked list and fail the authentication
if the sink is found to be present in the list.
Change-Id: I6615122f785bde94cb746ec4df7ab63b9f878528
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
During linkdown pci host cannot save the config space
prior to suspending the link. If saved_state is null
recover rc config space using shadow recovery.
CRs-Fixed: 2141146
Change-Id: I6c6e817ae2c32d8040853fe22785040480aa76eb
Signed-off-by: Sujeev Dias <sdias@codeaurora.org>
Issue:
When total_steps is updated, after that, copy_from_user
fails with an error, then, i2c_reg_tbl is not allocated.
In this case, when calling msm_actuator_parse_i2c_params,
it lead to out-of-bound memory write.
Fix:
1) Assign total_steps to zero when error from copying.
2) Add NULL pointer check for i2c tbl.
CRs-Fixed: 2111672
Change-Id: Ib9dcb182356e2df8078c131edfd0791fa95a35e0
Signed-off-by: Haibin Liu <haibinl@codeaurora.org>
Add device tree entry needed to support eeprom on the
irs1645 sensor.
Change-Id: I88ad09c7da813e3b74d465392e8e40839d9c88a9
Signed-off-by: Vivek Iyer <viyer@codeaurora.org>
FW now reports SNR for RX management frames.
Drop probe responses with SNR lower than the configured threshold.
Change-Id: Ife1863b07aebe5cb6097420290c0c10b590c2da1
Signed-off-by: Dedy Lansky <dlansky@codeaurora.org>
snr_thresh sysfs can be used to set omni and direct SNR threshold for
connection.
Change-Id: I091a6b61a1a4cb98e0e8c0f70b2fff4d22486e61
Signed-off-by: Dedy Lansky <dlansky@codeaurora.org>
Do not need to do HDMI PHY reset here, because will do
that when HDMI cable connected again in HDMI mode setting
function.
Change-Id: Ifae7c35f72a9008980c207e0806ab7aaa57dfe07
Signed-off-by: Yuan Zhao <yzhao@codeaurora.org>
Due to delay of ~3 sec between core reset response
and core init cmd, i2c send fails as NFC controller
goes to deep sleep state if its idle for ~1sec.
Delay caused due to logs in driver probe sequence.
Delay is added after every gpio state change to
ensure, modified value is taken into consideration
and unnecessary delays are removed.
Change-Id: I4c6e8f867f641d6648139206244d67bb556e0099
Signed-off-by: Gaurav Singhal <gsinghal@codeaurora.org>
Cuurently as a part of start host, after the block reset we
are performing core init and gadget restart of the dwc3
controller. This causes crash for host only controller where
ep0 and ep1 have not been initialised but are being
dereferenced. Also, HW reinitialisation is not required for
start or restart host routine.
Change-Id: Ie2b781ecb03a1d0a02c5f4305d518adc18dc6ade
Signed-off-by: Ajay Agarwal <ajaya@codeaurora.org>
Add support for registering SPI slave controllers using the existing SPI
master framework:
- SPI slave controllers must use spi_alloc_slave() instead of
spi_alloc_master(), and should provide an additional callback
"slave_abort" to abort an ongoing SPI transfer request,
- SPI slave controllers are added to a new "spi_slave" device class,
- SPI slave handlers can be bound to the SPI slave device represented
by an SPI slave controller using a DT child node named "slave",
- Alternatively, (un)binding an SPI slave handler to the SPI slave
device represented by an SPI slave controller can be done by
(un)registering the slave device through a sysfs virtual file named
"slave".
From the point of view of an SPI slave protocol handler, an SPI slave
controller looks almost like an ordinary SPI master controller. The only
exception is that a transfer request will block on the remote SPI
master, and may be cancelled using spi_slave_abort().
Change-Id: I251c5b7247ee7088285e42dd3b3cdce9c56cb9f7
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@kernel.org>
Git-commit: 6c364062bfed3c34490e85bea52ff6e2d4f0f281
Git-repo: git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
Signed-off-by: Alok Chauhan <alokc@codeaurora.org>
Max bandwidth vote on each bus device is required to be
printed when the device panics, so add a panic notifier
to print the max BW votes on each bus device.
Change-Id: I2256407638fe5085cb4b0f4d5a594dd00f4f3bce
Signed-off-by: Odelu Kukatla <okukatla@codeaurora.org>
msm8996 auto CDP platform missing vddio power supply to power up
adv7533 bridge chip for DSI interfaces, which converts DSI to HDMI
signal. This change adds power rails to adv7533.
Change-Id: Ieaea589803bbac1d42478fff16e8a4a833cf7426
Signed-off-by: Rahul Sharma <sharah@codeaurora.org>
SSR framework is specific for MSM kernels. Refactor the callbacks
for SSR framework so that the same powerup/shutdown APIs can be
also used for non-MSM kernels where SSR framework does not exist.
Change-Id: Ic7bcafadc4f7ad3bd2fab0a4b672b2f5676fe401
Signed-off-by: Yue Ma <yuem@codeaurora.org>
In the case of ffs_free_inst() called, whole ffs_dev structure is
freed. Userspace related API do not check if ffs_dev is freed or
not.
If ffs endpoint is opened by userspace, ffs_free_inst() is executed,
mark inst_exist to false but do not free instance structures until
ffs_data is freed.
Besides, ffs_data is allocated in ffs_fs_mount() while opts->dev
is allocated when ffs instance created. And opts->dev will
be freed when ffs instance freed.
If ffs instance is freed and created once, opts->dev is allocated
to new memory, but since ffs_fs_mount() won't be called in this
case, new opts->dev miss the ffs_data address and
ffs_data->private_data still point to old opts->dev address which
is already freed.
So new allocated opts->dev need to initialize opts->dev->ffs_data,
and ffs_private_data also need to update new allocated opts->dev
address.
Change-Id: Idea56f86c62da700926e8ce3a724d5be6295a4fd
Signed-off-by: Liangliang Lu <luliang@codeaurora.org>
