PMI GPIO1 is used to enable and disable WLED for msm8998 QVR,
we should also invert the gpio level according to HW design.
CRs-Fixed: 1101647
Change-Id: If29e41d12a697d7fd6671f1134a1e798c80c3523
Signed-off-by: Yahui Wang <yahuiw@codeaurora.org>
If read function is waiting for interrupt and after that
NFCC goes to recovery, MW will call ioctl (0) and ioctl (1),
In ioctl (0) call we are disabling interrupt so read function
was waiting for interrupt and ioctl call has disabled interrupt,
now there is no possibility interrupt will be enabled again
because only read function enables the interrupt.
Enabled interrupt in ioctl (1) so that we can receive data
after reset/recovery.
Change-Id: I1677a50129534b1eaa4b8c20820a15db299cd9c1
Signed-off-by: Gaurav Singhal <gsinghal@codeaurora.org>
Some platforms don't configure qcom,secondary-pon-reset like 8998.
So set boot_reason when "qcom,system-reset" node exists to avoid
setting a wrong value to boot_reason.
CRs-Fixed: 1102732
Change-Id: I9e9ff2f2d0ffac6baa5d0663664001eb30638e87
Signed-off-by: Mao Jinlong <c_jmao@codeaurora.org>
Add IPA stats support on AP+STA mode for V2 driver
when CNE queries. Also add metering funtionality
on WIFI interface to stop the data transfer
when quota reached on WIFI-case.
Change-Id: I51a771423e6a35ea0453b978be484d0464bddf14
Acked-by: Chaitanya Pratapa <cpratapa@qti.qualcomm.com>
Signed-off-by: Utkarsh Saxena <usaxena@codeaurora.org>
Add TLB dump entries to setup memory space for the cpuss dump
driver to dump TLB entries.
Change-Id: I7514969c1540d18d2102088b43d959adec68152f
Signed-off-by: Runmin Wang <runminw@codeaurora.org>
GPU RBCPR clocks needs to registered separately, as GFX CPR would require
the rbcpr clocks to register the regulator handle.
Change-Id: I59def76e7dd69600be8faf47eb867a97ab04739e
Signed-off-by: Amit Nischal <anischal@codeaurora.org>
Signed-off-by: Taniya Das <tdas@codeaurora.org>
Following are the changes made:
1. Add CLK_IGNORE_UNUSED flag for some clocks which are not
supposed to be disabled at late_init_level.
2. Fix clock measure debug mux value for mmcc clocks.
3. Add mmss_mdss_byte1_intf_div_clk for mdp.
4. Fix usb ref clocks to branch voted.
Change-Id: I06396c73f7855acfac283abe576e0b4cc1a92bd5
Signed-off-by: Taniya Das <tdas@codeaurora.org>
qpnp_pin_debugfs_create() is going through all the child nodes
to create debugfs entries whereas the allocation for q_spec is
made only for available child nodes. This leads to a null pointer
access when CONFIG_GPIO_QPNP_PIN_DEBUG is selected in defconfig.
Fix it by using number of gpios available under each gpio chip
which was populated from the available child count already.
Change-Id: I17cbeeba158d34180763087103da4b03e01f7c90
Signed-off-by: Subbaraman Narayanamurthy <subbaram@codeaurora.org>
Add 710MHz to A540 GPU power level on msmcobaltv2 as per
the hardware recommendation.
CRs-Fixed: 1085733
Change-Id: Iceff8329caf939ad3b34d6a750f056026853c76a
Signed-off-by: Oleg Perelet <operelet@codeaurora.org>
