Update GFX PM-QoS entries according to the measured
LPM latencies for SDM630 to prevent l2-pc.
Change-Id: I3a59a26bf19d79393c4b45c8a3b243897f3f6eb2
Signed-off-by: Deepak Kumar <dkumar@codeaurora.org>
It is observed that the USB_PHY may interfere with APSD
when the charger is inserted at PON. This may lead to
incorrect charger type detection.
Fix this by doing a APSD re-run during driver initialization
if USB is present and regardless of the charger type.
CRs-Fixed: 2011764
Change-Id: Icc9ee7bacf0eecdb311ca52979758514abca154e
Signed-off-by: Anirudh Ghayal <aghayal@codeaurora.org>
commit 82f2935616 ("usb: gadget: f_mass_storage: Allow USB LPM
upon ep disable") just increments power usage count by 1 for dwc3 device
in thread handler. Since child count for dwc3 parent remains 0, there is
possibility of dwc3 parent going into suspend even if dwc3 power usage
count is set to 1. This causes unclocked register access as mdwc gets
runtime suspended and mass storage thread handler disables the endpoint.
Fix this issue by calling usb_gadget_autopm_get_async() in set_alt which
increments dwc3 power usage count and carry out resume asynchronously.
Change-Id: Iccce928590d8e67e234f0aa371f78eb1e6a326b7
Signed-off-by: Mayank Rana <mrana@codeaurora.org>
Due to an existing HW workaround, the UFP_EN_CMD bit may end up
getting cleared even after having been set. The result of this
is the Type-C state machine returns to DRP behavior despite SW
intention to force sink mode, such as PR Swap or Try.SNK.
Temporarily disable this particular HW trigger whenever the
typec_power_role property is getting set to sink-only mode, and
restore it when leaving sink mode.
Change-Id: I21e840bfeee3ad88b0562645378b1fea200e3803
Signed-off-by: Jack Pham <jackp@codeaurora.org>
Signed-off-by: Abhijeet Dharmapurikar <adharmap@codeaurora.org>
pimem bus master is starving for data from ddr and time out is
observed with QoS priority set to 0, so increase the QoS priority
for pimem bus master to 1.
Change-Id: Ie90d0a41953e03d8cba9843fd8fb4f7dc511a62d
Signed-off-by: Odelu Kukatla <okukatla@codeaurora.org>
In runtime resume scenarios we first enable the HW resources, clocks and
then set the gpio to UART functionalities. When GPIOS are changing the
state RX line samples as zero resulting in RX Break detection. This stops
data coming from BT SOC sending to the BT host causing failures.
Modify the GPIO config sequence such that GPIO functionalities changed
only when resources like Clocks are OFF.
Change-Id: Iaf3b7c7a66dd83fc631e4a779a804ef98836e00b
Signed-off-by: Mukesh Kumar Savaliya <msavaliy@codeaurora.org>
