Remove the incorrect Ainfo transfer to the sink during the
start of repeater test cases for the HDMI HDCP 1x module.
This causes incorrect results from sinks which are repeaters.
Fix the logic to disable software DDC before going into
part3 of HDCP 1x authentication.
Change-Id: Iddf1c5804162ecd3919a0d4fedc9102e3b1778ed
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Currently, deep color mode flags are not being cleared
across connect-disconnect of HDMI cable. This leads to
stale information being present on the next successful
connection.
Clear the stale deep color mode flags before updating the
modes during a connection event.
Change-Id: I90d494a67dfb1c3fd464f1e1ffb24592bd712702
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Add support for ov9282 dual camera sensors with the images from
the two sensors stitched together.
Change-Id: I4ac5aecca4d7ecc4fb9d04a6fdf64c871f486cbf
Signed-off-by: Sathish Ambley <sathishambley@codeaurora.org>
Acked-by: Rajesh Bharathwaj <rajeshbharathwaj@codeaurora.org>
Add battery profile data and pinctrl changes that are specific to svr835
v2 board.
Change-Id: I85c5e7ce7e88655da5637d2e5bc14ce8593b09d0
Signed-off-by: Sathish Ambley <sathishambley@codeaurora.org>
Acked-by: Rajesh Bharathwaj <rajeshbharathwaj@codeaurora.org>
WCN3990 target uses new connect service for pktlog.
Add pktlog service request and support for pktlog
rx handling.
CRs-Fixed: 2038976
Change-Id: I6f7dbd8f8cbeadd0e53844154a9c360011e2c798
Signed-off-by: Govind Singh <govinds@codeaurora.org>
Signed-off-by: Ashutosh Kumar <askuma@codeaurora.org>
Add support to update the HDMI AVI infoframe to use
BT2020 encoding during HDR video playback.
This is required as per the spec to ensure that the
AVI infoframe correctly indicates the content being
shown.
Also make sure to change and restore the YCC
quantization bits in case of override.
Change-Id: Iadacc2fac6252b5f5cbfcc39a122118f738d3113
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
The CSC matrix used in the CDM block should be
updated to BT2020 format from the default value
during HDR video playback.
Add support in the SDE driver to enable switching
CSC matrix of CDM block to BT2020 during start of
HDR playback and restore it at the stop of the
playback to the default CSC.
Change-Id: Ic589380188ddef8ada2c8bbc0ca945bb1f319c85
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Currently only BT601 CSC matrix is available for use
in the SDE driver.
Add BT709, BT2020 CSC matrix definitions to SDE driver.
These shall be used during different use-cases such as
HDR video playback by switching the CSC matrix based on the
use-case.
Change-Id: I70a543193d08217cbdb6c4af739b3777dde4a25d
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
CDM block is always using a limited quantization range
matrix.
This can be overridden to use a full range matrix if
the sink supports override capability or the mode is a
non-CEA mode.
Adjust the matrix selection logic to accommodate these
conditions.
Change-Id: I708412a923fb0d47e798f35ebe14b4c2f1a72fc9
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
This reverts commit 9ec3ce38d7.
This change brings one NULL pointer in display kernel booting, which
will bring crash on msm8996 lite board. So revert this commit temporarily.
Change-Id: I7e11b78b47f0e2f2f5cc05a0220f1ff7f3a1addd
Signed-off-by: Guchun Chen <guchunc@codeaurora.org>
Add a device specific flag for new vmid heap shared feature.
Change-Id: I9be679f9edd0048acbb057ceff4d877c630e4258
Signed-off-by: Tharun Kumar Merugu <mtharu@codeaurora.org>
Only HDMI INTF3 should need cdm block, other
INTFs do not need cdm.
Change-Id: Iff355dae456ed432efd84dff72ec85b83dbb93f2
Signed-off-by: Yuan Zhao <yzhao@codeaurora.org>
Since 'timestamp' is of unsigned int type, for larger timestamp
the format specifier %d can show negative values. Fix this by
using %u format specifier for timestamp.
Change-Id: I621dfd4843099cb27436006500fe3342d1d5ddf4
Signed-off-by: Abhilash Kumar <krabhi@codeaurora.org>
Provide support to enable/disable sw jeita using a power supply
property.
Change-Id: Id1c2a4bcd8caece5ed7591dc5ab5bf3ac2207cba
Signed-off-by: Abhijeet Dharmapurikar <adharmap@codeaurora.org>
Disable sending dummy BDF(board data file). Enforce to use real BDF
by default.
Change-Id: Ib0cf267af8ddea8a702f8ac6774063466094f52e
CRs-fixed: 2059087
Signed-off-by: Yue Ma <yuem@codeaurora.org>
